Cypress Semiconductor NoBL CY7C1472V33 Guia do Utilizador descarregar pdf (Página 6)

Orange Tree Technologies

Page 6 of 57

6 Installation

6.1 Packing List

Please check that the following items are in the package sent to you and contact Orange

Tree Technologies if any are missing:

1. ZestSC1 card in anti-static bag

2. Four self-adhesive rubber feet in the same anti-static bag as the card

3. ZestSC1 Support Software CD

4. USB cable

5. Installation Instructions printed sheet

6. Known Issues printed sheet

7. Power supply wall adapter, if ordered

Please read fully and then follow these installation instructions.

6.2 Hardware

1. Check that your target system in which ZestSC1 will be used meets the system

requirements of the previous section.

2. Ideally all these installation operations should be performed in an anti-static

environment with an anti-static workbench and anti-static wrist-straps.

Alternatively if this is not possible you should earth yourself regularly during

installation by touching an unpainted earthed metal surface.

3. If required, stick the self-adhesive rubber feet in the four corners of the board.

4. Place the board on a flat surface close enough to the host PC so that the USB cable

reaches between them.

5. Set the jumpers as required – see the Headers section. The board is supplied with the

default settings, which should be sufficient for getting going initially.

6. If the board is to be self-powered then one of the following two options should be

used:

a) Optional. If a mains power wall adapter is to be used, plug it into the board with

the adapter switched off and then switch on the adapter. This prevents voltage

ringing in the cable. The plug from the mains power adapter should have

+5V power on the outside of the pin and ground on the inside of the pin.

When the plug is inserted in the jack, power from USB is disconnected by the

jack.

b) Optional. If a PC hard disk power connector is to be used, plug it into the board

with the power source switched off and then switch on the power source. The PC

hard disk drive power connector is intended for use of the board inside a PC and

the board should be mounted securely using the four corner holes and insulating

1 2 3 4 5 6 7 8 9 10 11 ... 56 57

Sem comentários

Cypress Semiconductor NoBL CY7C1472V33 Guia do Utilizador Página 6