Cypress Semiconductor AN6077 Guia do Utilizador descarregar pdf (Página 96)

96 CY3687 MoBL-USB FX2LP18 Development Kit User Guide, Doc. # 001-68582 Rev. *B

MoBL-USB Development Kit Firmware Examples

18.A red breakpoint indication is seen in the margin next to the new breakpoint as shown in

Figure 8-32. Press RUN button as shown in Figure 8-33.

Figure 8-32. Breakpoint Indicator in Keil uVision2 IDE

Figure 8-33. Run button in Keil

19.Now press F3 on the development board (the KEY_F2 label equates to the F3 button). Program

execution halts in the Keil IDE and the LED does not increment.

20.Press Step Over as shown in Figure 8-34. Then press Run key again on the debugger.

Figure 8-34. Step Over Debug Button in Keil uVision2 IDE

21.Execution proceeds normally until F3 key is pressed on the development board again. When fin-

ished, press the Stop Debugging key and exit the Keil debugger.

Note: If the Keil debugging does not proceed then re-build the firmware project and redo steps

12-21



1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 106 107

Sem comentários

Cypress Semiconductor AN6077 Guia do Utilizador Página 96